Bending brass with the Fender Bender J Matthes I was positively giddy when I cracked the box on the final version of this tool. I couldn't wait to get some brass in this hefty piece of art. So why wait? I immediately grabbed some Voyager and went to the bench. These pics are the first shot, not trial, no error, I even wanted to see it form on the fret instead of down the score line. I clamped it in. Pulled it up. Squared it off . < Dropped it back down. Voila. (The rough area in the middle is etched stock numbers from the underside visible in preceding photo). Okay, now for the PE part: In. Up. Down. Done. Sorry, it's not much of a desciption, but in this case, it isn't needed. To purchase this item, click below. J Matthes resides in New York where he needs to seriously thank Ted. copyright©2005 ausfwerks